Logitech G25 racing wheel - Review

Installation

Mounting the steering wheel to either your desk or race frame can be accomplished in several ways. The steering wheel makes use of a dual clamping system and with the aid of two plastic screw knobs, located on the top of the main wheel enclosure, can be mounted on your tabletop. After tightening the knobs these can be sunk down into the casing by pushing down on them and turning them a quarter way thus ensuring that these don't stick out obtrusively.

After tightening the knobs these can be sunk down into the casing by pushing down

An extra that will be greatly appreciated by the somewhat more serious sim-racers is the option to attach the wheel to a raceframe through the two threaded screw holes located on the bottom of the unit, this allows the steering wheel to be attached securely to the frame without fear of it moving around.

The steering wheel can be mounted by using either the dual clamping system or the threaded screw holes.

Main unit

The Pedal, gear shift and power supply are all attached to the main steering unit. Logitech uses male and female 9-pin connectors for the cables. When the main unit is attached to your table top it is virtually impossible to disconnect any of the cables.

The pedals and shifter are connected to the main unit.